Monoblock Power Amplifier.Delivers an astonishing 1000 watts into 8 ohms and doubles
down to 2000 watts at 4 ohms and a crazy 2300 watts into 2 ohms! Runs ' load independent' into either a 120V or 240V source. Proprietary Class D amplifier topology with power factor correction circuitry [ like SUB2 ]. Built in line conditionerthat cleans the signal going in and out. Internal cooling pipes to dissapate heat from the output stage. Dimensions [ HWD] : 5.7cm x 49cm x 47.6cm. weight 9.1kg
SPECIFICATIONS
Power Output continuous, 20 Hz to 20 kHz, <0.1% THD+N
|
8 Ω 1000 W 4 Ω 2000 W 3 Ω 2400 W 2 Ω >2000 W depending on line voltage regulation
With 120V AC supply the amplifier’s maximum output into impedances 4 Ω and lower, as well as its maximum duration, vary depending on line voltage regulation
|
Frequency Response 20 Hz to 20 kHz
|
Open circuit +/- 0.1 dB 8 Ω +/- 0.1 dB 4 Ω +/- 0.1 dB 2 Ω +/- 0.2 dB
|
Power Bandwidth 1000 W at 8 Ω
|
5 Hz to 45 kHz
|
THD+N at 1 kHz, 8 Ω
|
1 W 0.01 % 10 W 0.01 % 100 W <0.03 % 1000 W <0.06 %
|
IMD 19 kHz + 20 kHz, CCIF
|
0.003%
|
S/N Ratio ref. 1000 W, IEC-A |
113 dB
|
Voltage Gain |
29 dB
|
Input Sensitivity
|
100 mV for 1 W output, 3.2 V for 1000 W output (8 Ω)
|
Input Impedance |
10 kΩ (RCA), 20 kΩ (XLR)
|
Damping Factor |
800 to 1400 depending on frequency
|
XLR Configuration
|
Pin 1: Ground,
Pin 2: Positive,
Pin 3: Negative
|
Power Requirements
|
Consumption in a typical music/theater installation standby mode, 120V mains <1 W standby mode, 240V mains <2 W operate mode, idle 33 W typical operation 300 W
|
Dimensions
|
Height with feet2 1/4 inches (5.7cm)
Height without feet1 rack unit
Width standard handles19 1/4 inches (49 cm)
Width rackmount handles19 inches (48.3 cm)
Depth18 3/4 inches (47.6 cm)
Weight (unpacked)20 lb (9 kg)
|
|